2 HP SPL Compressor Duty Electric Motor 3450 RPM 56 Frame 5/8" Shaft 120/240V AA

Description

Features:
2 HP SPL 3450 RPM, 56 Frame, 120/240V, 15/7.5Amp 5/8" Shaft, Single Phase NEMA Air Compressor Electric Motor
Open dripproof Single phase Full Load amps: (7.5 FLA @ 240V) (15 FLA AT 120V) 2 HP SPL 3450 RPM 5/8 Shaft in. NEMA
Reduced starting amperage design to ensure the reduced voltage starting at rated load.
Equipped with UL approved Manual thermal overload, capacitors and high quality ball bearings to ensure the lifetime.
Open drip-proof is better used in environment that are relatively clean and dry environments. Special design for Air Compressor duty. CCW only.
Special design for Air Compressor duty.
Motor is Non-Reversible CCW (Counter Clockwise) ONLY.
Default settings are default low-voltage current. If the need to use high-voltage current, please replace the use of high voltage wiring.
Technical Info:
Type:COMPRESSOR DUTY MOTOR
Power Source:AC
Model:2M
AC Phase:Single Phase
AC Frequency Rating:60 Hz
Base RPM:3450 RPM
Enclosure Type:ODP (Open Drip-Proof)
Full Load Amps:15
Fram Type:56
Shaft lenght:2 1/16"
capacitor:star and run
Service Factor:1.0
Rated RPM:3450
Amperage:(7.5 FLA @ 240V) (15 FLA AT 120V)
Shaft Diameter:5/8" Keyed shaft
PH:1
AMB:40℃/104℉
Duty:CONT.
CODE:F
INF.CL:F
Warranty: 3 Year
PROFESSIONAL INSTALLATION IS REQUIRED.
PACKAGE LIST
1 x 2 HP SPL Compressor Duty Electric Motor
1 x Manual
Please Feel free to contact us with any questions you have relating to our products.
Kindly Tips:
Below is a quick check list for you to reference when sizing up the right motor for your application.
1. Amperage
This is your electric motors TRUE power rating. Please make sure your FL amp (FULL LOAD) rating on the motor you're replacing is within 10% of the FL Amp rating of the motor you intend to buy.
2. Frame Size
The frame not only constitutes the bolt pattern, it also depicts the overall size and torque. The larger the frame, the stronger the motor. It's extremely important that you replace it with the same frame size. Improperly sized motors will inevitably result in motor failures.
3. Phase and Voltage
If your machine requires a 230V electric motor on single phase power. You would want to incorporate a 1-phase 230V AC electric motor for your application. 230V electric motors cannot handle voltages less than 208V. They will run too hot and you will experience motor failure.
4. RPM
Matching up the RPM is quite important. The wrong speed can damage your pump. The RPM does not have to match exactly, but you do need to be the neighborhood.
Example: 3510rpm, 3550rpm, 3450rpm are all the same. They are all fall under the umbrella of whats known as 3600RPM motors.
5. Shaft Diameter
With a tape measure. Measure the outside diameter on your electric motors shaft. By matching up the proper shaft diameter, you will be able to reuse the original motor pulley that came on your machine.