9 in 1 LCD display Intelligent Control Dual Pulse Farah Capacitor Spot Welder

Description

Home
Arduino
Module
Sensor
Chips
About Us
Product features:
1. Using high quality materials, durable
2. This spot welder control board uses 5 MOS tubes in parallel, high current durable and not blow up the tube, double pulse output, can set the pre-welding time, pulse time, delay time, interval time
3. LCD screen display intuitive display, simple operation of parameter setting
4. High power spot welding, easy to continuously spot welding 0.3mm nickel-plated sheet for many times
5. Wide range of applications
Parameters:
Two charging methods (power supply self-provided).
1. Control board Type-c port charging.
Voltage: 5V
Current: 2A
2. Direct capacitor positive and negative charging.
Voltage: 5-5.4V
Current: 3-20A
Note: 1. If you need to spot weld while charging, please use a high current power supply to charge the positive and negative terminals of the capacitor. It is forbidden to spot weld while charging with TYPE-C interface, it will damage the spot welder and charging head.
2. If you are spot welding 0.3mm nickel-plated sheet, the voltage must be charged to 5.4V.
3. Over-voltage and over-current are prohibited for charging, please charge strictly according to the parameter requirements.
3. When charging, the control board switch should be turned off and turned on after full use.
4. It is forbidden to charge voltage exceeding the capacitor's voltage value of 5.4V.
Spot welding is the use of high current local rapid high temperature melting nickel sheet and the principle of cooling welding.
Welding thickness: 0.05- 0.3m m nickel-plated sheet
Need to spot weld 0.3mm nickel-plated sheet voltage needs to be filled to 5.4V
It is prohibited to spot weld pure nickel sheet, lithium iron monolithic aluminum and copper pole lugs as well as soft clad aluminum pole lugs.
Tips.
This spot welder, suitable for spot welding 18650, 21700, 26650, 32650 battery assembly spot welding.
Prohibit spot welding cell phone batteries, large monolithic, soft pack batteries, or damage at your own risk!
Package list:
Control board * 1
Spot welding pen * 2 (10 square pen can not change the soldering needle, 12 square pen can be changed)
Faraday capacitor * 2
Capacitor base * 1
Charging line *1
Nickel sheet *1
Acrylic protective case *1
Payment
Shipping
Refund
Payment
We accept PayPal only.
But we only
Accept
your
Ebay Address
,Please Make sure it's 100% right.
Payment must be received in 5 business days of auction closing.
Please leave note for your special request (e.g. Colors or Size) in PayPal when you pay the order.
Any special request cannot be accepted after 24 hours of payment, because most of orders will be processed instantly and same day dispatched.
Shipping
Fill your shipping info
Refund
All package need to
wait 30 days
(US only n
eed 7-10 days)
,
Please take care it.Less than 30 days,we can't take a refund
.
If the item is defect when you receive it or you are not satisfied with it, please return it within 14 days for a replacement or money back. But the items must be back in factory condition. Please contact us and double check the return address before you return it.
If is item is defective in 12 months, you can return it to us. We will send you a new replacement after receiving the defective item.