Mini Ugly Stick Model RC Airplane YELLOW Easy Kit With Pre-Cut Covering

Description

Mini Ugly Stick RC airplane ARF kit. Under 10 oz total flying weight! 23" wingspan. Fits a wide range of RC airplane brushless motors, as well as common drone electronics. This is the perfect park and yard flyer! The airframe is 3D printed. It's much tougher and a little lighter than balsa. These will take a beating! The covering is a vinyl-type adhesive covering that comes pre-cut. It's like putting on a stickers - very simple!
Check it out on 3D RC Hobby!
This high-wing model is a great trainer for beginners who are just getting into the hobby, but also great for aerobatics. With stable flying at high or low speeds, this is a great choice for flyers of all skill levels.
The Ugly
Stick
ARF (Almost Ready to Fly) Kit comes with the complete airframe, pre-cut covering & decals, control surface hinges, along with pushrods & servo horns,
and instructions. The Ugly
Stick can be ready to fly in less than one hour. All you need is a small amount of glue (CA or Super Glue),
a battery and your choice of electronics
(not included).
Airplane Specifications:
Material: 3D printed (PLA MAX)
Control Type: Throttle, Ailerons, Elevator and Rudder.
Wingspan: 23 inches
Length: 16 inches
Flying Weight: Approx. 10 oz (varies slightly with motor and battery size)
Recommended electronics
(NOT included):
Servos: 3.7 gram micro (x4)
Motor Size: 1806-2200 800+ kv
ESC: 12 amp with BEC
Propeller: 5-6 inch
Battery: 2s lipo 7.4v 200-400 mAh with XT30 connector
Radio / Receiver: 4-channel radio / receiver
*The photos show the plane with motor and propeller. These are NOT included*