Sur-Ron 31mm Foot Peg Extender Bracket Package Forged Segway Surron FIX

Description

SUR-RON FIX 1.250 INCH FOOT PEG DROP MOUNTING BRACKET PACKAGE FORGED SEGWAY SURRON REPAIR MOD
Forged Aluminum Construction to Ensure the Strongest Foot Peg Mounting Brackets Available!
In stock - Usually ships the same business day
» Direct Bolt-On
» Strongest Design
»
Black Anodized Finish
» Eliminate Foot Peg Failures
»
Drops Foot Peg 1.25 Inches
»
Uses Factory Mounting Hardware
»
Replaces Weak OEM Cast Brackets
»
Forged
Aluminum Foot Peg Mount Support Brace
»
1 Pair = 1 Left Peg Bracket and 1 Right Peg Bracket
» Won't Fail Like Factory Sur-Ron Cast Foot Peg Brackets
»
Three
M14x1.25
Threaded Holes on the bottom of each peg bracket
» Dependable Replacement Foot Peg Mounting Brackets for Sur-Ron MX
» Installed picture on a bike that makes power with a nucular 24F controller
»
See
pictures of the weak cast sur-ron frame bending as they come from the factory
»
UPR Forged Foot Peg Mounting Bracket and Support Brace Eliminate Frame and Peg Failures
Description:
UPR's NEW Forged Foot Peg Extender Brackets for Sur-Ron MX
electric bike
made from
FORGED
aluminum. These Forged brackets are a Direct Bolt-On
giving you an instant 1.25 inches of drop to allow a more comfortable ride.
Includes Foot Peg Support Brace to protect against all jumping, hard riding
and against general fatigue that the cast foot peg brackets suffer from.
Does not include kickstand and simply uses all factory parts to swap
over for ease of installation.
Installation Tip:
Be sure to always use anti-seize when installing the UPR Forged Foot Peg
Mounting Brackets and Support Brace System. This will allow the frame
to be evenly pulled back into place when tightening as its very common
for the frames to be bent inward causing a gap when trying to install the
mounting brackets.
The anti-seize will ensure a smooth thread operation and allows the bolts
to be turned easily without extra stress. Be sure to tighten each side evenly
so it pulls the frame peg mounts back out to the original location. Some times
one side will be bent more than the other as people have a tendency to lean
to one side more than the other.
Once you have gotten the frame to contact the mounting bracket surface
evenly and have the support brace installed you are done. As long as you take
your time and go slow and with returning the frame back to its original location
you will have brought your frame back to 100% and boxed it properly with the
new mounts and support brace eliminating this from happening ever again.
* Never grab the kickstand and try and bend the mount to get the kickstand from
contacting the swingarm. The kickstand is hitting the swingarm because the
mounting bolt location in the frame is bent and that is the main reason the
support brace was designed to correct this problem.